FIRECLASS Fire Alarm Control Panels 2.3 RBUS Node Pseudo Points
Fault Finding Guide Doc. version 2 9
2.3 RBUS Node Pseudo Points
When reported on the user interface or via printers, the
output format used for faults reported from RBus node
faults is:
RBnn’
where nn is the node number 0–15.
This section refers to faults regarding the
presence or absence of complete nodes. It is
NOT an indication of faults held by the node.
This set of points uses a different address
structure. Because the RBUS units can be
addressed from 0–15, the first address is
‘Zero’.
Point
Address
Label Use
0–15 RBUS Fault Used by the RBUS or the COMMS driver to indicate loss of
configured nodes or the presence of unconfigured nodes and
other fault states such as ‘F/W INCOMPATIBLE’.
The logged event text will give more details on the specific
fault that is detected. Options include ‘NO RESPONSE’ and
‘UNCONFIGURED DEVICE’.
Table 3: RBUS Node Pseudo Points
To Next Page
Loading...
