Firman WH03342 - WH03342_Manual_English _Page_12

FEATURES AND CONTROLS
9. Battery Power Restore Switch
10. DC SV 2.1A USB Outlet
11. Circuit Breakers - The receptacles are protected by AC circuit protectors. If the generator is
overloaded or an extern a I short circuit occurs, a circuit protector may trip. If trip ping occurs,
disconnect all electrical loads and determine the cause before attempting to continue using the
generator. Reset any tripped circuit protectors.
If multiple receptacles are used at the same time, the total current must be kept with-in the
portable generator data decal rating.
12. 12V DC Battery Charger Port - Plug the 120 Volt AC charger into this port to charge the
generator battery.
13. DC Circuit Breaker- The DC receptacles are protected by an DC circuit protector. If the DC output
is overloaded or an external short circuit occurs the circuit protector will trip.
14. Parallel Operation Outlets -These outlets are used for connecting two FIRMAN inverter
generators for parallel operation. A FIRMAN parallel kit(optional equipment) is required for
parallel operation.
15. DC 12V Output - 8.3 Amps of DC current may be drawn from this receptacle. Use this outlet to charge
12V automotive type batteries ONLY. See 12V DC outlet (Battery Charger) section.
16. Ground Terminal - Consult an electrician or authority having jurisdiction for local grounding
requirements.
17. Outlet Cover - Protect the receptacles from dust and debris.
18. Recoil Starter
19. LPC Hose Connector (Inlet: 3/8" Flare Male) - Used to connect LPG hose to generator.
20. Fuel Selector Switch - Use to select and turn on gasoline or LPG fuel source. Fuel (gasoline)
valve is closed when the switch is on "OFF" or "LPG" positions. Engine switch is on when the switch
is on "GAS" or "LPG" positions.
21. Choke Knob - Used to start a cold engine.
22. LPC Regulator Solenoid Port
23. CO Alert™ Carbon Monoxide (CO) Shutdown Indicator Light - Indicates the engine shutdown due
to carbon monoxide accumulation around the generator or a CO Alert system fault occurred.
English 10 Customer Service 1-844-FIRMAN1