Firman WH03342 - WH03342_Manual_English _Page_27

OPERATION
6. Stopping the generator
1. Turn off and remove all electrical loads.
Never stop the generator with electrica Id evices plugged in and turned on.
Never stop the engine by moving the choke to the start position.
Let the generator run at no-load for one minute to stabilize internal temperatures of the engine
and generator.
2. Flip the engine switch to"OFF"(O] position.
3. Turn the main fuel selector switch to "LPC" position (1:30 o'clock). The gasoline valve is closed
in this position.
4. Fully close the LPG cylinder knob.
If a cover is used, do not install until unit has cooled.
NOTICE Disconnect the LPG cylinder from the generator during transportation.
English 25 Customer Service 1-844-FIRMAN1