EasyManuals Logo

Firstech CM6200 User Manual

Firstech CM6200
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #25 background imageLoading...
Page #25 background image
*Set the reservation time at 7 am (see User’s guide)
**Turn on Timer Mode of the 2 way LCD remotes (see User’s Guide)
2-07 Remote Start Runtime - This option give you four different settings for the remote start run time. This
available options are 15, 25,45, and 3 minutes.
2-08 Temperature of Cold Starting – Works in conjunction with Options 2-05 and 2-06. See the option
table for available temperatures.2-09
2-09 Temperature of Hot Starting – Works in conjunction with Options 2-05 and 2-06. See the option
table for available temperatures.
2-10 Engine Sensing – Review the “Common Procedures” section for complete explanations on the four
engine sensing modes.
2-11 Advanced Tachless- This feature when used in conjunction with feature 2-10 option 3 will provide
an enhanced Tachless engine sensing mode.
2-12 Min. Crank Time - This feature applies to feature 2-10 option 3 and 4. It will add or remove crank
time to the default setting of the afore mentioned options 3 and 4.
2-13 Timer Mode - This feature enables the user to operate Timer Mode (see option 2-06). Remember
that the user must still activate Timer mode using the remote (see the user manual for that remote for
instructions).
3-01 Parking Lights while Remote Started - This option changes the parking light behavior during remote
start.
3-02 Confirmation chirps- This feature will allow the user to select a shorter siren output time to simulate
a quieter arm/disarm/start output. (only available with feature 3-06 option 2)
3-03 Dome Light Delay – This feature is used when connecting the door trigger input to the vehicles a
delayed dome light circuit. It delays reading the door trigger input for the selected amount of time
to prevent the door open icon displaying on 2 Way remotes upon lock/arm. Option 4 “auto” will
look for a change in polarity before it starts to monitor the door input (only available with feature
3-06 option 2)
3-04 Starter-Kill – This option determines the mode of the anti-grind/starter-kill relay.
Default 1: Anti-grind + starter-kill
Option 2: Anti-grind only (no starter-kill)
Option 3: Anti-grind + passive starter-kill: starter-kill activates in 45 seconds after ignition is turned
off.
CM6200 Install Guide
Starter System
www.firstechonline.com | www.compustar.com
Copyright 2012 Firstech, LLC.
Page 25

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Firstech CM6200 and is the answer not in the manual?

Firstech CM6200 Specifications

General IconGeneral
BrandFirstech
ModelCM6200
CategoryRemote Starter
LanguageEnglish

Related product manuals