24
12 Deleting the specification limits
1. Switch to the specification limit mode
using the button [] or [].
2. Press button [OK]. The set
value appears on the display.
3. Set the value to "0.00" using the key [] or [].
4. Press button [OK] to accept this value into memory. The MAX value will be set to zero with this action.
0.00 will appear on the display.
5. The
value can be set to "0.00" using the button [] or [].
6. Press button [OK]. The mode will be left.
Now the specification limits no longer apply. The MIN and MAX values are deleted from the memory.
The instrument is ready to make measurements.
To Next Page
Loading...
