5
1 Switching the instrument ON / OFF (valid for all instrument models except the “…-FP” models)
Note: The instrument does not have a specific ON / OFF switch.
Switching the instrument ON
The instrument will switch ON automatically when it is placed on a specimen. If the instrument is placed on
nonferromagnetic or electrically nonconductive material, the display will show the error note "Er6" and then four
horizontal bars instead of a reading.
PLEASE NOTE!
Do not
power up the instrument by pressing a finger on the sensor! It may result in erroneous measurements.
Switching the instrument OFF / Auto-Switch-Off
After a certain time, the instrument will switch off automatically (OFF = when instrument’s display is empty)
You can set the period from the last measurement to the automatic OFF from the service mode.
See chapter 14 “Service Menus”, page 27.
To Next Page
Loading...
