EasyManuals Logo

Fisher & Paykel OR36SDPWGX Installation Instructions

Fisher & Paykel OR36SDPWGX
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #17 background imageLoading...
Page #17 background image
17
17
WARNING:
Do not remove drawer while
hot.
Do not remove drawer du-
ring operation.
Be sure drawer is empty be-
fore removing.
Always position your hand
below the front panel to
open/close the drawer.
2
CONVERSION TO LP/PROPANE GAS (OR CONVERSION BACK TO THE ORIGINAL GAS - NA-
TURAL GAS)
Every range is provided with a set of ori ces for the various types of gas.
Select the ori ces to be replaced according to the “ORIFICES TABLE”.
The nozzle diameters, expressed in hundredths of a millimetre, are marked on the body of each ori ce.
CAUTION: Save the ori ces removed from the appliance for future use.
SETTING THE PRESSURE REGULATOR
The pressure regulator is accessible by removing the warmer drawer; the pressure regulator is positioned on the rear right side of the
range ( g. 2.9).
To remove the warming drawer:
1. Open the drawer completely ( g. 2.8)
2. Move down the lever of left guide ( g. 2.8a) and up the lever of right guide ( g. 2.8b).
3. Remove the drawer holding the levers in the same position ( g. 2.8).
Fig. 2.8a
Fig. 2.8
Fig. 2.8b

Other manuals for Fisher & Paykel OR36SDPWGX

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fisher & Paykel OR36SDPWGX and is the answer not in the manual?

Fisher & Paykel OR36SDPWGX Specifications

General IconGeneral
BrandFisher & Paykel
ModelOR36SDPWGX
CategoryRanges
LanguageEnglish

Related product manuals