23
Wash cycle options
Wash Boost
Pre Wash
For extra dirty loads you can perform a PRE WASH. Your washer will start the wash with a short
wash in cool water to remove excess soil. After this the machine will drain and then fill at the
selected temperature for the main wash.
If you use the PRE WASH option, liquid or powdered detergent needs to be placed in the
correct detergent compartment. The pre wash compartment is on the right hand side of the
drawer, marked “1”. When you select PRE WASH, the compartment is flushed at the start of
the cycle. The detergent for the main wash must be a powder, and should be placed in the
compartment marked “2”.
Simply touch the WASH BOOST button and select PRE WASH when choosing your wash options.
Note: PRE WASH cannot be selected after a wash cycle has been started, ie if you touch
START / PAUSE and try to select PRE WASH it will be unavailable. PRE WASH must be selected at
the start of the cycle.
Rinse+
If you have a particularly dirty load, or you have sensitive skin and wish to give your clothes an
extra rinse, select RINSE+ from the WASH BOOST options. Your load will undergo an extra rinse to
get rid of any residual detergent or soil in the items.
Note: RINSE+ will not be available if the ECO option has been selected.
Options
Wrinkle Free (WashSmart™ only)
We recommend you remove the clothes from the washer immediately after the completion of
the cycle to minimise wrinkling and creasing of items and to prevent dye run. However, if you
will not be present at the end of the wash you can select WRINKLE FREE.
When WRINKLE FREE is selected, the washer will tumble the clothes once every 15 minutes for
up to 12 hours after the cycle has finished. The WRINKLE FREE light and START / PAUSE button will
flash, and the washer will beep at regular intervals to remind you to remove your load. To remove
the load during this phase, simply press the START / PAUSE button.
Eco
Use the ECO option to save water and energy. Selecting ECO will reduce the wash temperature
slightly and alter the wash time. Note: this option will not be available if PRE WASH has been
selected.
If you wish to, you can select both the PRE WASH and RINSE+ WASH BOOST options to perform
on the same cycle. Likewise, you can select ECO and WRINKLE FREE to perform on the same cycle.
Touch the appropriate button until both options are selected. Repeat to deselect an option.
For clothes care and performance reasons not all options may be available on some cycles.
Add a Garment (WashSmart™ only)
The ADD A GARMENT option enables you to add or remove items during the wash stage of the
cycle, under certain conditions. Once the ADD A GARMENT button is touched, the START / PAUSE
button and TIME REMAINING will flash. Wait until you hear the door unlock. Open the door and add
or remove items. Close the door and touch START / PAUSE to restart the cycle. The ADD A GARMENT
button will only operate during the wash part of the cycle and when the temperature selected is
lower than 60°C. ADD A GARMENT can be used when the total wash volume has been reached, as
your washer will drain the water to a lower level if necessary so the door can be opened.
EN
To Next Page
Loading...
Need help?
General
