31
Fault codes
When a continuous series of beeps is sounded, all the lights turn off on the control panel and
a number appears on the display, a fault has occurred. The washer will automatically enter
this mode if a fault occurs. The fault code will be displayed as “Err” followed by a number on the
digital display. To stop the sound, touch any button and perform the following steps:
1
Turn your machine off at the power point.
2
Wait 1 minute and turn it back on.
3
Check your machine is correctly levelled (refer to page 4).
4
Remove your wash load and retry.
5
Perform a RINSE cycle.
6
If the fault re-occurs repeat steps 1 and 2.
7
If the machine still will not work you will be required to call a Fisher & Paykel Authorised Repairer
to arrange service (refer to page 38). Record the fault code number displayed and the serial
number of your washer (located on the rear of the machine, and / or above the drum opening
when the door is open) before calling. The fault code will indicate to the Repairer what the
problem could potentially be.
If a fault code is being displayed, you can still turn your washer off by pressing POWER.
EN
To Next Page
Loading...
Need help?
General
