24
Wash cycle options
Keylock
This option enables you to deactivate the buttons on the display panel, except for the POWER
and KEYLOCK buttons. This prevents accidental button presses.
To turn Keylock mode ON or OFF, when the washer is powered on:
Touch and hold the KEYLOCK button for 2 seconds.
Note: when activated, the light above the KEYLOCK button is illuminated.
If Keylock mode is activated and the machine is powered off:
To turn your washer on, press the POWER button, then touch and hold the KEYLOCK button for
twoseconds to turn KEYLOCK off. Select your wash cycle, options and then START / PAUSE to
start the cycle.
To turn the washer off at anytime when KEYLOCK is activated, simply touch the POWER button.
Delay Start
The DELAY START option enables you to delay the start of the wash cycle from between
5minutes and 12hours. Times you can select are 5min, 15min, 30min, 1hour, then hourly
up to 12hours. This can be useful to time your washing to finish when you arrive home from
work, or to start once you have finished in the shower. Certain stain removers also require you
to spray them on then leave for several minutes, before washing. Your washer will wait for the
selected time then start without you having to wait or remember to start your machine.
To programme a DELAY START time, simply touch the MORE
button to increase the delay
time and LESS
button to decrease the time or turn DELAY START off. Touch START / PAUSE
to confirm your selection and start the countdown. Once started, the time will countdown
on the digital display panel in 1 minute increments, the DELAY START light will flash and the
START / PAUSE light will stop flashing and turn on solid.
Note: if you hold the MORE
button down, the time displayed on the screen will increase
after every half a second (more convenient than touching the button repetitively).
To remove a delay start time once it is counting down, simply touch START / PAUSE, then
touch the LESS
button to decrease the time to zero. Touch START / PAUSE to start the cycle
immediately.
Note: we suggest that you avoid using DELAY START for damp, non-colourfast items as this
may cause dye run to occur. We also recommend you use powder detergent when you use the
DELAY START function.
EN
To Next Page
Loading...
