Installation instructions
4
Location
Install the machine on a solid and level floor surface ensuring it has at least 20 mm clearance on
each side. The washer must not be installed on any textured floor coverings (eg carpet, rugs).
Levelling the machine
It is IMPORTANT to level the machine to ensure good spin
performance, and to minimise noise, vibrations and wear
and tear on the washer.
1
Before positioning the machine in its final position, check
that the machine is level, front to back and side to side.
2
Manoeuvre the product into its final position (we suggest a
minimum clearance of 20 mm each side).
3
Use a spirit level to check that the machine is correctly level.
If needed, pull the machine out and wind the feet up or
down to correctly level the machine.
4
Using the spanner provided, tighten the lock nuts against
the base of the machine to lock the feet in position.
Connecting to the water supply
Inlet hoses
Important!
New hose sets provided with the washer should be used to
connect the washer to the water mains.
Old hose sets should not be re-used.
We recommend the inlet hoses are changed every 5 years.
WARNING: Failure to do so may result in a flood and
damage to property.
1
Connect the straight ends of the inlet hoses to the taps
and the elbow ends to the corresponding machine inlet
valves. The hot valve is colour coded orange to make this
easier. Make sure there are no kinks in the hoses.
2
Turn the taps on and check for leaks. Check for leaks again
after 24 hours.
Important!
The hot water temperature should not exceed 65°C and the cold water temperature not exceed35°C.
Temperatures above these may cause the machine to fault or cause damage to the machine.
Fig.3 Locking the feet
Fig.4 Inlet hose ends
Elbow
(machine) end
Straight
(tap) end
EN
To Next Page
Loading...
Need help?
General
