6
Installation instructions
Electrical connection
1
This appliance must be connected to a 220 V – 240 V, 50 Hz, sinusoidal, 10 A electrical supply.
2
Uncoil the power cord, remove and discard the plastic pin cover and plug into a wall socket.
3
Connect the appliance to an earthed outlet protected by a fuse of suitable capacity.
Check the power cord for damage and make sure it is not squashed or twisted when installing
the washer.
Always remove the power cord from a socket by the plug, not by the cord.
Important!
If you are using an extension cord or a portable electrical outlet device (eg multi-socket outlet
box), ensure that it is positioned so that it does not come into contact with water or moisture.
FAILURE TO DO SO MAY RESULT IN DEATH OR ELECTRICAL SHOCK.
Do not touch or operate the machine with wet hands or with bare-feet.
A damaged power cord must be replaced by a Fisher & Paykel Authorised Repairer, its service
agent or similarly qualified persons in order to avoid a hazard. The appliance must not be
operated until it is repaired, as there is risk of electric shock.
Do not operate this machine if it has been damaged during transport. Contact your
Fisher & Paykel Dealer or Fisher & Paykel Authorised Repairer.
Spare parts
Available from your Fisher & Paykel Dealer or a Fisher & Paykel Authorised Repairer.
Hose Inlet Long (2 m) Part No. 422680P
Hose Inlet Large Bore Part No. 426123P
Drain Hose Extension Part No. 425627P
EN
To Next Page
Loading...
Need help?
General
