Fisher & Paykel WH8060P1 - Removal of Kick Panel; Removal of Cabinet Bellows Clamp; Removal of Control Panel

479646
19
7.2.3 Removal of Kick Panel
1. To remove the kick panel, open the pump cover
and drain the pump of any water (refer to
Section 2.18).
2. Remove the screw.
3. Carefully unclip the kick plate from its locking
clips.
NB. If too tight to free, then remove the base panel
and release the 5 clips from the inside of the front
panel.
Reassemble in the reverse order
7.2.4 Removal of Cabinet Bellows Clamp
1. Undo the screw holding the clamp in position.
2. Unhook the wire clamp to separate and remove.
3. Remove bellows from cabinet.
Reassemble in the reverse order
7.2.5 Removal of Control Panel
1. Follow the procedure for removal of top panel
(refer to Section 7.2.1).
2. Remove dispenser drawer by pressing down on
the area indicated by the word push on the
siphon inside the dispenser.
3. Remove the 2 screws securing the control panel
to the dispenser housing.
4. Remove the 2 screws securing the top edge of
the control panel to the cabinet.
5. Remove the control panel from the front of the
cabinet. Lift up to release the locating spigots
then forward to clear the dispenser housing.
6. Remove the wiring harness from the display
module.
Reassemble in the reverse order.