1. To remove the drum, follow the procedure for
removing the top panel (refer to Section 7.2.1).
2. Remove the kick panel (refer to Section 7.2.3).
3. Remove the cabinet bellows clamp (refer to
Section 7.2.4).
4. Remove the control panel (refer to Section
7.2.5).
5. Remove the front panel (refer to Section 7.2.7).
6. Lock the drum assembly by refitting the 4 transit
bolts.
7. Remove the counter weights from the front of
the tub.
8. Lean the machine back and remove the front
left shock absorber bolt from the chassis.
9. Disconnect the tub to pump hose at the pump
end and stand the machine upright.
10. Remove the pressure tube from the pressure
sensor.
11. Undo the screws holding the tub front to the rear
section and remove the front half of the tub.
12. Use a fine slot screw driver to release the cap
from the centre of the cover at the rear of the
drum. Remove the cover by undoing the screw.
To Next Page
Loading...
