Lit. No. 68660/68661, Rev. 04 13 January 15, 2014
OPERATING THE SPREADER
CAUTION
Do not swing spreader with material in the
hopper.
NOTE: Always place the cover on the hopper to
prevent moisture buildup. Do not let the spreader
sit idle with material in the hopper for an extended
period of time. This can cause the material to
compact and reduce or stop the ow of material.
SPREADER CONTROLS
There are two control options: the ON/OFF Control
and the Variable Speed Control.
ON/OFF Control
Starting and Stopping the Motor
1. Turn the control ON to start the motor. The motor
will start immediately. The power switch will
remain in the "ON" position.
2. Turn the control OFF to stop the motor. The power
switch will remain in the "OFF" position.
The ON/OFF switch operates as an emergency
stop when required.
NOTE: The truck ignition must be ON to start the
spreader.
NOTE: If the truck ignition is turned OFF while the
spreader is running, the motor will stop.
NOTE: Always place the cover on the hopper to
prevent moisture buildup. Do not let the spreader
sit idle with material in the hopper for an extended
period of time. This can cause the material to
compact and reduce or stop the ow of material.
WARNING
Before starting the spreader, the driver shall
verify that all bystanders are a minimum of
25 feet away from operating spreader.
ON
OFF
RESET
15
POWER
Circuit Breaker
(resets control)
/OFF Control Switch
(emergency stop
To Next Page
Loading...
