5-4
Configuration
(FISHER;)
The measuring range is set using FCODE 1 to 3.
Function Parameters FCODE Range
Unit
Increment Default Selected
V&Je
ValLJe
Measuring Min value 24 + 9999 any 1 digit
0.0
range Max value
25 + 9999 any 1 digit 100.0
No. of
26 O-4 1 1
5.4.1.5
The parameters should be inserted in the order
FCODE 26 thru 24 (number of decimals first) to
obtain the correct values.
Example:
A level controller is to regulate between 0.39 and 1.16 inches (10 and
30 mm). The sensor supplies 0 mA for 0 inches (0 mm), and 20 mA
fpr 1.97 inches (50 mm). Set FCODE 3 to 1, FCODE 1 to 0.0 and
FCODE 2 to 500.
Signal Range Selection
Use FCODE 119 thru 122 to select the appropriate electrical signal
range and linearization option for each of the four analog inputs, All
thru Al4. Select one of the options. To enable the square root option
for Al 1, use FCODE 107.
nction FCODE Option No Default Selectel
Value V&e
All
119 4-20mA. 1-W
1 1
O-20mA. 0-W
2
Al2
120 4-20mA, 1-W 1 1
O-20mA, 0-5V 2
4-2OmA, 1+X square root 3
&2OmA, 0%5V, square root 4
Al3 121 4-20mA, 1-W
1 1
O-20mA, 0-W 2
4-ZOmA, I-.5V, square root 3
0-2OmA, 0-5V, square root 4
Al4 122 4-20mA, ILW 1 1
0%ZOmA, 0-W 2
4-20mA. I-W, square root 3
0-20mA. 0-5V, square root 4
Function
FCODE Option No Default
Selected
Value Value
Calculation to7 Disabled 0 0
of Process square root 1
Variable
R = (All x Ratio) + Bias 2
R z All + (Al3 x Ratio) + Bias 3
R = (All x Ratio) + Al3 + Bias
4
R = (All x AI3)(Ratio) + Bias
5
UM6.1:DPR900:9102
May 1991
To Next Page
Loading...
