Confk7uraiion 5-57
n
PROG appears on the display, the user now has full access to
function and parameter changes.
n
See Tuning Parameters/Configuration Changes for instructions to
make appropriate changes.
If the programming mode is exited before
changing the authorization, you must start the
procedure from the beginning.
5.16
Resetting the Controller
Use FCODE 144 and 145 to reset the controller to the default values.
Function FCODE
Option No Default Selected
V&X V&If?
Resetting
144 Reset disabled
0 0
Reset Autotuner 1
Reset Gain Scheduling 2
4b
Caution
Pressing the STORE button when this
FCODE is displayed will reset the entire
controller.
Function FCODE Option No Default Selected
VZ3llle Vallle
Resetting 145 Reset disabled 0 0
Reset configuration 1
5.17 Software Version Number
When addressing specific questions about the application and
operation of the DPRSOO Integral Controller, it is necessary to
have the software version number available. Select FCODE
45 and press the TUNE button to view the installed software
version number. The display may read 9147 for example,
DPWOO-055
meaning year 1991, week 47.
Change 2 -July 1992
lJM6.1:DPR900:9147
To Next Page
Loading...
