Chapter Software Operation Ⅲ
Instructions of Control Terminal
1 Workflow Overview
In order to make it easier for users to understand the operation and use of
the software, this document describes the operation procedure and related
auxiliary functions of the operating workflow of the kit from a new user's
perspective. A new user needs to complete the installation, configuration and
preparatory operations before using the kit for the first time and smoothly
entering the auto steering driving
2 Commissioning
The initial commissioning process of FJDynamics Autosteering kit is as
follows:
Select a language → Register and log in to your account → Enter
installation information → Connect to RTK → Set vehicle parameters →
Calibrate the angle sensor → Calibrate the whole vehicle → Complete
commissioning
Figure 3.2.1 Initial commissioning workflow
©FJ Dynamics Technology Co., Ltd. All rights reserved.
To Next Page
Loading...
