2.5.2. Dangers from hot surfaces
Parts of the device heat up during operation. There is a risk of burns if there is direct
contact with hot surfaces. To avoid this, please note the following
Safety instructions:
• Do not touch hot pipes or the housing of the circulation pump when the device is
switched on. Do not do so until it has been switched off and cooled down.
• Wear suitable protective gloves when touching or working on hot parts.
2.5.3. Dangers from electricity
The device is powered by electricity. Touching live
Components can result in serious injury or death. To avoid this, please observe the
following safety instructions:
Disconnect the main power supply before working on electrical equipment
• Disconnect the main power supply before working on electrical equipment.
• Make sure that the power cable is equipped with an appropriate locking device for
maintenance purposes (lockout-tagout).
Liquids
• Be careful when handling liquids. Penetrating liquids can cause short circuits or
electric shock.
Connection data
• Observe the specified electrical connection data (see section “10 Technical data” on
page 37).
Covers of electrical components
• Do not open the covers while the device is switched on or in operation.
• Do not remove covers when wiring or checking, even when the power is turned off.
11
Sideflow Clean Pro
> Safety instructions
ENG
To Next Page
Loading...
