flamco Sideflow Clean Pro - Maintenance;Cleaning; Maintenance & Cleaning

6.2. Maintenance/Cleaning
In this section you will find the cleaning of the built-in dual filter
To clean the filter, proceed as follows:
1.
2.
1. Close the inlet and outlet valves. Open
the KFE tap to release the pressure.
Then open the vent valve
top of the filter. Unscrew the wing nut
and remove the cap.
2. Remove the magnetic rod and clean it,
for example with a cloth.
3.
4.
3. Then remove the compression spring
and clean it if necessary. with water.
4. Now you can remove and replace the
basket with the fine filter bag. (Spare
part number 17016)
Assembly is done in reverse order.
The dual filter on the magnetic bar should be directed towards the input to achieve
the highest capacity.
35
Sideflow Clean Pro
> Maintenance and repair
ENG