2.4.2. Installation (as in 'to install')
The device may only be installed by authorized and trained specialists.
Improper installation may result in injury. To avoid this, please observe the following
safety instructions:
• Do not place heavy objects on the device.
• Place the device on a level and sufficiently stable surface.
• When connecting the device to the power supply, make sure that the mains voltage
corresponds to the information on the type plate.
• Have the device connected to the power supply and earthed by qualified personnel
in accordance with national regulations.
• Use an omnipolar switch with a gap of at least 3 mm between the contacts to
connect the device to the power supply.
• Install a residual current circuit breaker (0.03 A) as additional protection against
electric shock.
• Lay cables and hoses so that they do not pose a tripping hazard.
• If tripping hazards cannot be avoided, mark them clearly.
• Carry out adjustments or simple repairs in consultation with the manufacturer.
• Do not make any modifications to the appliance or to the water and electricity lines.
• Position the device so that the circulation pump motor is sufficiently ventilated.
2.5. Dangers during operation and maintenance
2.5.1. Mechanical hazards
The device consists of moving or heavy components. This can cause injury to people.
To avoid this, please observe the following safety instructions:
• Be careful when replacing heavy parts: - Wear suitable safety shoes. - Secure the
device against tipping or slipping.
• When carrying out maintenance work on supplied components, please observe the
relevant documentation from the relevant manufacturers.
• Do not place your hands on rotating or moving parts of the device while it is in
operation.
10 We reserve the right to change the design and technical specifications of our products.
To Next Page
Loading...
