FLAMMA FX200 - System: Footswitch Mode and Spill-Over; Footswitch Mode Selection; Delay;Reverb Spill-Over Effect

www.flammainnovation.comShenzhenFlammaInnovationCo.,Ltd
34
SYSTEM
FSMODE
NORMAL:Traditionalfootswitchmode,pressortocyclethroughpresetbanks,thenpressfootswitch
AorBtoselectpresetpatch.
FAVORITE:Youcanassignfourfavoritepresetpatchesintofourfootswitches.Inthismode,pressand
holdafootswitch,thenselectapresetpatch.PressandholdtheVALUEtoconfirm,thenyoucanpress
thefootswitchtoaccessyourfavoritepresetpatchthatyoujustsetup.
DLYREVSPILL-OVER
Youcansetupthetrailfunctionofthedelay/reverbeffects.
Whenitissettoon,whenyouturnon/offdelay/reverbeffect,orswitchingbetweentwopresets
whichbothhavedelay/reverbeffect,thepresettonewillfadeoutnaturally.
Notes:
1.Whenswitchingbetweentwopresetpatcheswithdelay/reverb,togetthebestresult,the
parametersettingofthosedelay/effectmoduleshouldnotbeextremelydifferent.
2.Ifthedelay/reverbtypesoftwopresetpatchesaredifferent,thetrailofpresettonewill
notfadeoutnaturallyifyouswitchbetweenthesepresets.