FLASHFORGE 3D PRINTER finder - Page 16



Finder User Guide | www.flashforge.com 0086-0579-82273989
16
yReturn arrow
Tap [Setting] to enter the setting interface
yLanguage: To set the display language
yWIFI: To turn on/off the WIFI
y Wlan hotspot: To turn on/off the Wlan
hotspot.
yServo Calibration: To turn on/off the
servo or adjust the servo.
yExtruderCalibration: To adjust the initial
distance between the extruder and the
build plate.
yFilament Check Off: To turn on/off the
filament check
y Factory Reset͹return to factory setting
yUpdate: To update the firmware version.
yReturn arrow
WIFI:
yTurn on WIFI: Turn on the WIFI, release
the WIFI hotspot and set the WIFI on
computer
yReturn arrow