Finder User Guide | www.flashforge.com 0086-0579-82273989
78
needed. Press down the left mouse button and drag to generate the support.
2
Manual Delete
8-11
Like the picture above, a hole inside the model doesn’t need any supports.
Left click the [Delete] button and then left click the supports needed deleting. And the
support will be deleted.
8.2 Control over Printing Quality
Enhance the build plate adhesivenessķ
Leveling the build plate
Keeping the build plate smooth and tidy
Using the build tape or glue
Adjusting the printing speedĸ
Low (Fast) (Print Speed 80mm/s Travel Speed 100mm/s)
Standard (Print Speed 60mm/s Travel Speed 80mm/s)
High (Slow) (Print Speed 50mm/s Travel Speed 70mm/s)
Hyper (Print Speed 50mm/s Travel Speed 70mm/s)
8.3 Skills of Model Placement
To Next Page
Loading...
