Finder User Guide | www.flashforge.com 0086-0579-82273989
30
Chapter 5: Build Plate Leveling
Finder creatively adopts three-point intelligent leveling system, which will give clear
and comprehensive feedback to users. There are three spring-loaded knobs under the
build platform. The distance between the plate and nozzle increases while tightening
the knobs. On the contrary, the distance reduces.
(5-1) Tap [Tools] - [Level] on your Finder touch screen. Please wait while the extruder
and platform finish initial movements. After that, operate according to the guide on the
touch screen.
5-2
51
To Next Page
Loading...
