Finder User Guide | www.flashforge.com 0086-0579-82273989
42
Z Planeĺ
6.2.9 Supports
After loading the model, click
[Edit]--[Supports] or click the Supports icon directly,
then you will enter the support edit mode(as shown in the picture below). Click [Back]
to exit when you finish editing.
6-10
Support Options
Click the Support Options, an option box will appear, supports options include
“treelike”and “linear”, when choose “treelike”, click
[OK], then it will generate
treelike structure; when choose “linear”, click
[OK], then it will generatelinear
structure; if it is a model with supports, when you choose one of the supports
options,software will judge whether existing supports need to be deleted or not on the
To Next Page
Loading...
