Finder User Guide | www.flashforge.com 0086-0579-82273989
47
(6-14) Click[Edit], then you can add or remove a height.
6.2.11 File Menus
New Project
Click
[File]--[New Project] can build a blank project. If there is an unsaved
modification on previous project, then it will inform you whether the modification
needs to be saved or not. Click
[Yes ] will save the modification, click [No] will
abandon it. If click
[Cancel] or close tool tip, then will cancel the new project.
Saving
After finishing the model edit and adjustment, there are two ways below to save all
models in the scene.
Method 1:
Click
[File]--[Save Project] in the menu bar to save the file as a project file with the
“.fpp”suffix,all models in the scene (include support) are independent . After reloading
the files, extruder configuration information and model position will be the same as
the configuration during saving.
615
6-14
To Next Page
Loading...
