Finder User Guide | www.flashforge.com 0086-0579-82273989
66
Perimeter
1˅Thickness
a . Shell Count: Numbers of laps for each layer’s shell. Maximum: 10; Minimum: 1.
b. Maximum Path Overlap: Max amount of overlapping extrusion for some models,
especially small models.
2˅Speed:
a. Exterior Speed: Speed at which the exterior shell is printed.
b. Visible Interior Speed: Speed at which the visible interior shell is printed.
c. Invisible Interior Speed: Speed at which the invisible interior shell is printed.
3˅ Start Points
a. Mode: There are two options for Start Point mode. One is “closest to specific
location”, the other is “use random start points”.
b. X: The coordinate value of X
c. Y: The coordinate value of Y
Infill
General
a. Top Solid Layer: Number of solid layers on the upper surface of model.
8-3
To Next Page
Loading...
