FLASHFORGE 3D PRINTER finder - Page 71



Finder User Guide | www.flashforge.com 0086-0579-82273989
71
b. Path Width: The width of the path, the default value is 0.4mm. Keeping default is
suggested.
c. Path Resolution: The default value is 0.1mm. The bigger the value is, the lower the
extrusion resolution is. On the contrary, the extrusion resolution is much higher.








Others
DimensionalAdjustment
a.EnableAdjustments:Enablesoftwar etomakecompensationforerrors.
b. External Compensation: Enable software to make compensation for the outer
diametererror.
c. Internal Compensation: Enable software to make compensation for the inner
diametererror.







8-8

8-7