1. Tap [Build], and choose the
file path: Printer internal
memory, USB stick, or Cloud.
2. Choose the model file,
tap on its right to start
printing; or tap the model
picture or model name to
enter the detail page, and
then tap to start printing.
3. The extruder will heat up and the printer will start printing when it reaches the target
temperature. After printing is completed, the printer will make a beep sound and pop
up a prompt on the touch screen.
2.4.4 Printing
Ship-PLA.gx
1/1
Build completed
OK
20mm_Box-PLA.gx
Time Remaining
h min
Ship-PLA.gx
20mm_Box-P...
0 h 10 min
0.70 M
20mm_Box-
PLA.gx
1/1
Build
6.62 GB
Not Available
No Job
Tools
Filament
21
To Next Page
Loading...
