Flashforge Adventurer 3 Pro 2 - Page 42

Buzzer
Factory Setting Completed!
Restored to factory setting
Delete all data
in internal memory
Factory Reset
Update Extruder
3/4 Start OK
Move Camera
Filament Check Led
2/4
Move Camera
Filament Check Led
2/4
Move Camera
Filament Check Led
2/4
To turn on/off the filament
check. When enabled, a
prompt will pop up when
filament is used up or
broken.
Filament check:
To turn on/off the light.
LED:
Turn on or turn off the camera.
For more details about Camera, please refer to Chapter 2.6.
Camera:
39