Flashforge ADVENTURER 3 - Page 18

File details: Including file picture, time needed,
filament needed.
Build: To begin printing the file.
Copy: To copy the files to the local memory
card from the USB stick.
Delete: To delete the print file.
Cancel: To cancel the print job.
Pause/Resume: To suspend or resume the print job.
More: To check more settings and details information
during printing.
Print interface
More
Replace: To change filament during printing progress.
Pause when door open: To set pause/unpause when door open, default setting is pause.
Pause when door open: To set pause/unpause when door open, default setting is pause.
...
Detail
Extruder temperature
Build plate temperature
Used time
Printing progress
Printing progress
18
F-40mm_Box.gx
F-40mm_Box.gx
...
1
h
2
min
Time Remaining
warrior.gx
...
2
h
18
min
剩余
℃/
220
℃
220
85
℃/
100
℃
1 36
h min
M
25
7.49
%
h min
m
1
2
7.49