Q1. How to unclog the nozzle?
Method 1: Click [Load] and heat the nozzle to the printing temperature of the used filament. After
heating, remove the filament guide tube, and check if the filament is bent or filament
tip is not smooth. If so, trim and insert the guide tube and filament into the nozzle, then
click [Load] and check.
Method 2: If Method 1 doesn't work, use the unclogging pin tool.
Method 3: If Method 2 doesn't work, please replace the nozzle.
7. Q&A
Please power off the printer before replacing the nozzle!
Q2. How to replace the nozzle?
1. Remove the filament guide tube and
cut the filament.
2. Press the left and right buckles and remove the
nozzle. Trim the filament along the nozzle top.
3. Insert the new nozzle into the extruder and you can hear a "click" sound indicating the buckle
position has changed. Ensure that the nozzle slot aligns flush with the bottom of the extruder.
Note: If you have trouble aligning the nozzle, you can press the buckles during installation or
remove the front cover of the extruder (grab the lower part of the front cover with your hand
and lift it upward slightly) to check the position.
Note
30
To Next Page
Loading...
