Your Platform
Pay close attention: leveling your platform is very important to print quality!
Here’s the first screen
Those three dots mean the message isn’t over, so click the M when you’ve read the
screen and want to continue. Then you'll see this
After you finish reading this message, The Creator will tell you to tighten the knobs
on the bottom of the platform
These four knobs are the ones on the bottom of the platform, just inside the plastic
arms that hold it up. It's actually easier to level the platform if you don't tighten
these all the way. Instead, tighten each knob four complete turns. Then press the M
button.
To Next Page
Loading...
