Flashforge Guider II - Preface; Quick Start Guide; Official FlashForge Website

Unpacking
03
1. Open the box and remove both top foam
sheets.
2. Take your Guider II out of the box and remove
the bubble wrap.
3. The bottom PE foam should contain: filament,
spool holder, solid glue, USB cable, grease
and accessories bag.
4. Remove bubble wrap.
5. Remove the top PE foam piece,which
 contains a power cable, a Quick start guide
and a After-sales service card.
6. Use scissors to cut the buckles that hold the
 rods in the place.