Flashforge Guider - Manual Adjustment Controls

Guider User Guide | www.ff3dp.com
15
Tools
Tap [Tools] to enter tool options.
◆Filament: To load/unload the filament.
◆Level: To adjust the build plate.
◆Home: To make the X, Y and Z axes back
to the zero point.
◆Manual: To manually adjust the positions
of X, Y and Z axes.
◆Setting: To implement relevant function
setups.
◆Status: The check the real-time status of
the printer.
◆About: Information about the printer.
◆Return arrow
Manual adjustment
◆Y+: The extruder moves to the zero point,
that is, the back of the machine
◆Y-: The extruder moves to the direction
opposite to the Y+.
◆X+: The extruder moves to the zero
points, that is, to the right direction
◆X-: The extruder moves to the direction
opposite to the X+.
◆Z+: The build plate elevates.
◆Z-: The build plate descends.
◆Return arrow
The picture displays the preheat
interface. It shows the actual
temperature and the target temperature.
Tap the [Cancel] button to abort the
preheat job.