Guider User Guide | www.ff3dp.com
Click [View]--[Show Model Outline], it will highlight the yellow border of the
Click [View]--[Show Steep Overhang]. When the intersection angle between the
model surface and horizontal line is within the overhang threshold value, the surface
has steep overhang and it becomes red in the software. Overhang threshold value
could be set as needed. The default value is 45 degree.
Select the object and move the object by the following two methods:
Method 1: Click the [Move] icon on the left, hold down the left mouse
button and drag to adjust the location of the model in XY direction. Hold down the
Shift key, hold down the left mouse button and drag to adjust the location of the
model in Z direction. The distance and the direction of the movement shall be
Method 2: Click the [Move] button on the left and then enter the distance value.
Click [Reset] to reset distance values.
Note: Users shall click [Center] and [On Platform] after the location adjustment to
ensure the model(s) be within the build area and on the build platform. If a specified
position is needed, only to click [On Platform].
Select the target object and rotate the object by the following two methods:
Method 1: Click the [Rotate] icon on the left and three mutually
To Next Page
Loading...
