Guider User Guide | www.ff3dp.com
You can connect the Guider with your PC via a USB cable.
Note: The machine icon on the bottom right displays the connection status:
a. Connect your Guider with your PC via an USB cable.
b. Turn on your Guider and start Flashprint.
c.Click [Print]--[Connect Machine], then select USB in the [Connection Mode]
option and select machine you want to connect in [Select Machine] option. If you can
not find your machine, click the [Rescan] button to scan your machine and select it.
Finally click [Connect] button to connect to the printer. If you still can not find your
machine after rescan, which means you haven’t installed the driver in the software.
Click [Print]--[Disconnect] to disconnect your PC and Guider.
To Next Page
Loading...
