Guider User Guide | www.ff3dp.com
● Temperature Control: Input the temperature you want to get in the left frame,
click [Apply], the printer will automatically heat the corresponding part, the right side
shows the current actual temperature of corresponding part. After start heating, the
below curve of temperature form will start to change, different color correspond
different parts’ temperatures
② Update Firmware
Every time when you start Flashprint, it will automatically detect and download the
up-to-date firmware. If any update is available, a dialog box will pop up for reminding
Step 1: Click [Tools]--[Update firmware]. It needs to cut off connection before
updating firmware. If software and printer are already in connection, it reminds you
cutting off the connection, choose [Yes] and go on to the next step.
Step 2: Choose corresponding printer type and firmware version and click [OK] in
the firmware updating box. After confirming the printer is in free state, the software
will automatically update the firmware.
To Next Page
Loading...
