Guider User Guide | www.ff3dp.com
Step 3 ：Reboot you Guider and wait for 4-5 seconds, then you can see the update
process bar. When the update finishes, it will go back to the main interface.
Step 4：Tap[Tools]--[About] to check] to check whether the updated version is right.
When the computer and printer are in connection, click [Tools]--[On Board
Preferences], you can check the printer name.
When the computer and printer are in connection state, click [Tools]--[Machine
information], you can check the machine type, machine name and firmware etc.
① Help Contents：Click [Help]--[Help Contents], you can read the help contents.
② Check for Updates ： Click [Help]--[Check for Update] to detect the available
To Next Page