FlashPoint ZOOM TTL FLASH R2 - Wireless Flash Shooting: R2 Radio (2.4 G) Transmission; Slave and Master Unit Configuration; TTL Autoflash Setup

12
Slave Unit Setting
2. Setting Master Unit’s Flash Mode
4. TTL: Fully Automatic Wireless Flash Shooting
Autoash Shooting with One Slave Unit



2
2
2
Press Function Button 4
<
Gr
> to choose the
group from M/A/B/C. Then,
press Function Button 3
<MODE> so that the master
unit can work in OFF/TTL/M


master unit.
3. Setting the Communication Channel

channel IDs to prevent signal interference. The channel IDs of the

Press Function Button 3
<
CH
> and turn the
Select Dial to choose a
channel ID from 1 to 32
2. Press the <SET> button

Master Unit Setting
• Attach a Zoom Olympus/

camera and set it as the

• M/A/B/C can be set as TTL
mode indepe ndently.
Press < > button so
that < > and < >
are displayed on the LCD
panel.
The backlight now turns
orange to indicate Slave
Mode R2.

2. Press < MODE > button
to switch to Multi mode.