18
Using the Wide Panel
Pull out the wide panel and place
extended to 7 mm.
• The catchlight panel will come
out at the same time. Push the
catchlight panel back into place.
• The <ZOOM/C.FN> button will not
work.
Low Battery Warning
If the battery power is low, < >
will appear and blink on the LCD
panel. Please replace the batteries
immediately.
Custom Function
Signs
Function
Setting No. Settings & Description
C.Fn Custom Functions
m/ft
APO
ZOOM
Sv APOT
BEEP
LIGHT
LCD
m
ft
ON
OFF
4/3
135
60min
30min
ON
OFF
12sec
OFF
ON
0~9
Distance indicator
Lens system
Auto power off
Slave auto power
off timer
Beeper
Backlighting time
LCD contrast ratio
m
feet
ON
OFF
4/3 system
135 system
60min
30min
ON
OFF
Off in 12 sec.
Always off
Always lighting
10 levels
C.Fn: Setting Custom Functions
The following table lists the available custom functions of this
1. Press <Zm/C.Fn> Backlight/Custom Setting Button for 2
seconds or longer until C.Fn menu is displayed. The “Ver x.x”
in the top right corner refers to the software version.
2. Select the Custom Function No.
• Turn the Select Dial to select the Custom Function.
3. Change the Setting.
• Press<SET> button and the Setting No. blinks.
• Turn the Select Dial to set the desired number. Pressing
<SET>
• After you set the Custom Functions and press <MODE>
4. While in the C.Fn menus, a long press on the “Clear” button
for 2 seconds, until “OK”is displayed on the panel, the values
in C.Fn can be reset to the default values.
To Next Page
Loading...
