Operators and Reference Manual
MC12 OM RM EN 74-111-132 v1.03.doc Ver. 1.03 Page 2 of 47
1. DECLARATION OF CONFORMITY ............................................................................ 5
2. ABOUT THIS MANUAL ............................................................................................... 6
3. MC12 SYSTEM DESIGN ............................................................................................. 6
3.1 RS485
MULTIDROP NETWORK ........................................................................................ 6
4. GENERAL INFORMATION.......................................................................................... 7
4.1 U
NPACKING AND INSPECTION .......................................................................................... 7
4.2 C
ONNECTIONS MC12P .................................................................................................. 7
4.3 C
ONNECTIONS MC12 TABLE TOP MODEL ......................................................................... 7
5. CONTROL ................................................................................................................... 8
5.1 D
ISPLAY ........................................................................................................................ 8
5.2 K
EYPAD ........................................................................................................................ 9
6. PROGRAMMING ....................................................................................................... 10
6.1 S
TARTING THE MC12 ................................................................................................... 10
6.2 P
ASSWORD PROTECTION ............................................................................................. 10
6.3 P
ARAMETERS .............................................................................................................. 11
6.4 P
ROGRAMS ................................................................................................................. 11
6.5 G
ENERAL INFORMATION ON THE PROGRAMMING OF MC12 .............................................. 11
6.6 L
IST OF FUNCTIONS ...................................................................................................... 12
6.7 D
ESCRIPTION OF FUNCTIONS ........................................................................................ 13
6.7.1. Function 1 -Volume ............................................................................................. 13
6.7.2. Function 2 - Tube diameter ................................................................................. 13
6.7.3. Function 3 - Velocity ............................................................................................ 14
6.7.4. Function 4 - Acceleration/deceleration .................................................................
14
6.7.5. Function 5 - Reversing (back suction) ................................................................. 15
6.7.6. Function 6 - Batch size ........................................................................................ 15
6.7.7. Function 7 - Delay ............................................................................................... 16
6.7.8. Function 8 - Completed fills ................................................................................. 16
6.7.9. Function 9 - Specific gravity ................................................................................. 16
6.7.10. Function 10 - Output rate ................................................................................. 16
6.7.11. Function 11 - Accumulated volume .................................................................. 17
6.7.12. Function 12 - Maximum flow ............................................................................. 17
6.7.13. Function 16 - Pumping direction ....................................................................... 17
6.7.14. Function 17 - Timer 1 ....................................................................................... 18
6.7.15. Function 18 - Timer 2 ....................................................................................... 18
6.7.16. Function 19 - Timer 3 ....................................................................................... 18
6.7.17. Function 20- Operator number ......................................................................... 19
6.7.18. Function 21 - Batch number ............................................................................. 19
6.7.19. Function 22 - Start Log ..................................................................................... 19
6.7.20. Function 23 - Stop Log ..................................................................................... 20
6.7.21. Function 24 - Print Log ..................................................................................... 20
6.7.22. Function 25 - Delete Log .................................................................................. 21
6.7.23. Function 26 - Log Status .................................................................................. 21
6.7.24. Function 29 - Print parameters ......................................................................... 21
6.7.25. Function 31 - Save program .............................................................................
22
6.7.26. Function 32 - Load program ............................................................................. 23
6.7.27. Function 33 - Delete program ........................................................................... 23
6.7.28. Function 34 - Print programs ............................................................................ 23
6.7.29. Function 35 - Free memory capacity ................................................................ 24
6.7.30. Function 40 - Operating principle (Mode) ......................................................... 24
To Next Page
Loading...