Operators and Reference Manual
MC12 OM RM EN 74-111-132 v1.03.doc Ver. 1.03 Page 23 of 47
6.7.26. Function 32 - Load program
This function loads a program already saved and overwrites the current parameters with the
values of the program.
When pressing <3>+<2>+<ENT> the system will ask: “LOAD PROGRAM NO.:”
By pressing the required program number followed by <ENT>, the operating parameters
saved under the specified program number will be entered as the current parameters under
the respective functions.
At the same time, the following functions will be reset: F8 - F9 - F11 - F20 - F21.
If a calibration of the specific tube has been carried out, these parameters will also be
loaded.
If program number 0 is selected, the function is left without loading a program and the
system will keep the current values.
6.7.27. Function 33 - Delete program
This function deletes the required program.
If a complete program is to be deleted, this can be done by overwriting it via Function 31, or
the program can be deleted via Function 33.
When entering <3>+<3>+<ENT> the system will ask for the program number to be deleted.
When pressing the required program number followed by <ENT> the specified program will
be deleted.
If a number is entered under which no program is saved, the system will not accept it and the
number must be corrected, or the function can be left by pressing <0>+<ENT>.
6.7.28. Function 34 - Print programs
This function prints the individual parameters in all the programs stored in the memory.
When pressing <3>+<4>+<ENT> the system will ask: “PRINT PROGRAMS /Y/N):”
When pressing <N> the system will leave the function, without carrying out the function.
When pressing <Y> the system will start printing the parameters in all programs saved.
To Next Page
Loading...