FLIR A6700sc - Page 19

5 –Camera Controller
A6700sc/A6750sc User’s Manual 19
Frame
1 Data
Frame 1 Integration
Frame 2 Integration
Frame Sync
Frame Sync
Frame 2 Data
Frame 3 Integration
Frame Sync
Frame 3 Data
Frame 4 Integration
Frame Sync
Figure 4-3: Frame Sync Starts Integration, IWR
5.2.4.2.1.1.2 Frame Sync Starts Readout (FSSR)
Upon frame sync, the camera immediately transmits the data from the previous frame. The
integration period is then placed to meet ROIC requirements. This mode always operates in IWR
mode. This mode can be used with either internal or external frame sync at full frame rates.
Frame 1
Data
Frame 1 Integration
Frame 2 Integration
Frame Sync
Frame Sync
Frame 2 Data
Frame 3 Integration
Frame Sync
Frame 3 Data
Frame 4 Integration
Frame Sync
Figure 4-4: Frame Sync Starts Readout
5.2.4.2.1.2 Trigger Mode
When the camera is placed in a triggered mode, the image stream will stop until the trigger is
received.
Trigger Modes
Free Run (No Trigger)
In free run the camera cycles through frames/sequences
continuously.
Trigger then free run
Upon receiving a trigger (external or software) the camera will
start to generate sequences continuously.