FLIR Blackfly S - Keepout Layer-Board-Level Models

5 BlackflyS Physical Interface
BlackflyS Board-level Dimensional Drawing
5.3.1 Keepout Layer—Board-level Models
Board-level hardware can change without notice. The component envelope is shown above to assist in hardware
integration design. Areas marked in orange (front, back, and middle) are locations where components can change or
move, potentially affecting hardware integration as board revisions occur.
2/19/2019
©2015-2019 FLIR
Integrated Imaging
Solutions Inc.
All rights reserved.
FLIR Blackfly
®
S Installation Guide 18