FLIR Blackfly S - Non-Volatile Flash Memory; 5.12 Dust Protection-Cased Models

To Next Page

To Previous Page

5 BlackflyS Physical Interface

5.11 Non-Volatile Flash Memory

The camera has 6 MBflash memory for users to store data.

Title Article

Storing data in on-camera flash memory Knowledge Base Article 10370

Related Knowledge Base Articles

5.12 Dust Protection—Cased Models

The camera housing is designed to prevent dust from falling directly onto the sensor's protective glass surface. This is

achieved by placing a piece of clear glass (monochrome camera models) or an IR cut-off filter (color models) that sits

above the surface of the sensor's glass. A removable plastic retainer keeps this glass/filter system in place. By increasing

the distance between the imaging surface and the location of the potential dust particles, the likelihood of interference

from the dust (assuming non-collimated light) and the possibility of damage to the sensor during cleaning is reduced.

Warning! Cameras are sealed when they are shipped. To avoid

contamination, seals should not be broken until cameras are ready

for assembly on site.

Warning! Use caution when removing the protective glass or filter.

Damage to any component of the optical path voids the Hardware

Warranty. Removing the protective glass or filter alters the optical

path of the camera, and may result in problems obtaining proper

focus with your lens.

Title Article

Removing the IR filter from a color camera Knowledge Base Article 10080

Selecting a lens for your camera Technical Application Note 10694