FLIR Blackfly S - 5.8 Mounting Options

To Next Page

To Previous Page

5 BlackflyS Physical Interface

5.8 Mounting

Using the Case—Cased Models

The case is equipped with the following mounting holes:

n Two (2) M2 x 2 mm mounting holes on the top of the case

n Three (3) M3 x 2.5 mm mounting holes on the bottom of the case

n Four (4) M2 x 2 mm mounting holes on the bottom of the case that can be used to attach the camera directly to

a custom mount or to the tripod mounting bracket

Using the Mounting Bracket—Cased Models

Thetripod mounting bracket is equipped with four (4) M2 mounting holes.

Tripod Adapter Dimensions—Cased Models

Tripod Adapter Dimensional Diagram

Using the Mounting Holes—Board-level Models

Four mounting points are provided using M2 through holes. Additionally, an indexing key is available on the imager

board. When designing a mounting bracket, respect the Keepout Layer—Board-level Models.

Board-level Diagram

2/19/2019

Integrated Imaging

Solutions Inc.

FLIR Blackfly

S Installation Guide 26