FLIR Blackfly S - 3 Blackfly S Installation; 3.1 Preparing for Installation

3 BlackflyS Installation
3 BlackflyS Installation
3.1 Preparing for Installation
What system configuration is recommended?
Operating
System
CPU RAM Ports
Software to run and
compile example code
Recommended
System
Configuration
Windows7,
Windows8, or
Windows10
(32- or 64-bit)
Intel i5 4 GB
Intel USB3 host
controller
Microsoft Visual Studio 2010,
Visual Studio 2013, or
Visual Studio 2015
Note: Refer to Technical Application Note 10359 for important
information on recommended USB 3.0 system components.
Do you have all the parts you need?
To install your camera you will need the following components:
n For GigEcameras—Ethernet cable (see Interface Cables) and Powered Ethernet switch or Ethernet power
injector (if using PoE)
n For USB3 cameras—USB3 cable (see Interface Cables)
n For board-level models—TF38 to FPC USB3 or RJ45 PoE panel mount adapter
n For board-level models—Heatsink (recommended)
n For board-level models—FPC cable
n 6-pin GPIOcable (see General Purpose Input/Output (GPIO))
n For board-level models—Lens mount and lens (see Lens Mounting )
n Model dependent—CS-mount (or C-mount with adaptor) Lens (see Lens Mounting )
n Model dependent—C-mount Lens (see Lens Mounting )
n Tripod adapter (optional) (see Mounting)
n Interface card (see Interface Card)
FLIR sells a number of the additional parts required for installation. To purchase, visit the Accessories page.
2/19/2019
©2015-2019 FLIR
Integrated Imaging
Solutions Inc.
All rights reserved.
FLIR Blackfly
®
S Installation Guide 3