15
Configuring Remote Connection
5. Your Account information will be sent to you at the email address you
used in Step 2. Record your Account Information below.
Domain Name:
User Name:
Password:
Step 5 of 6: Enable DDNS on the camera:
1. Enter the camera’s IP address in your web browser. Log in and then click
Netw
ork Service>DDNS.
2. Check Enable
DDNS.
3. Configure the f
ollowing:
• Provider: Select
FLIRDDNS.
• Domain Name: Enter the Domain Name you received from the
confirmation email you received after you created your DDNS account
(e.g.
tomsmith.myddns-flir.com
).
• User Name: Enter the User Name you received in the confirmation email.
• Password: Enter the Password you received in the confirmation email.
4. Click OK
to save settings.
Step 6 of 6: Connect to the camera’s DDNS address:
1. Enter the camera’s DDNS address in your web browser in the following
fo
rmat:
http://tomsmith.myddns-flir.com:80
DDNS address
Colon
HTTP port number
http://
2. Under User Name and Password, enter the camera’s User Name
(default: admin) and Password (default: admin) and click Login.
Once you have logged into your system using your DDNS address, you can
connect to the IP camera from a remote location using a web browser,
Syncro-V, or other VMS software.
To Next Page
Loading...
